The hardware is basically the portion corresponding to the remote monitoring equipment. It consists of an electromagnetic field reception and measurement block, a block where processing and averaging and data memorization is performed, and a communication section that transmits the data to the control center.
In addition, the hardware is equipped with a programmable oversight system that sets off alarms if the field detected is stronger than the programmed upper limit. It also has other alarms warning of a low battery, open door, and so on. The system itself will advise the control center if an alarm is set off.
Continuous measurement of the strength of electromagnetic fields
Integrated Isotropic and RMS field probe. Simultaneous measurement along the three axes
GSM-GSM1800-UMTS, broadband and low frequency measurements
Data averaging (according to international standards)
"Sliding window" function (averaging without data losses)
Periodic storage of the measured data
Individually programmable alarm system: field level, low battery, hibernation, opening, ...
Online / Offline working mode
GPRS communication with Control Center
USB port and memory card
Power Supply: 220V, solar, SAI, hybrid (smart energy)
Easy installation: wall-mounted, mast-mounted or platform-mounted