Services FAQs Distributors Contact us Site map
Introduction
Products
SMP - EMF Meter
Description
Applications
Characteristics
Accreditation / calibration
Law
Standards
MonitEM - Continuous Monitoring Systems
Description
Applications
Hardware
Data Control Center
Accreditation / calibration
MapEM - Electromagnetic maps
Applications
Display and management of information
Probes
Applications
Mobile Telephony
Electric Power
Telecommunications
Integrated monitoring solution
Data integration
LabCal Wavecontrol

WPF8
 

FAQs

Frequently asked questions on our EMF measurement (non-ionizing radiation) solutions



What is the main function of continuous measurement systems (RFMS)?

What is the main function of continuous measurement systems (RFMS)?

These systems allow us to obtain and provide public access to data, namely to monitor and communicate. Continuous measurement systems allow ongoing monitoring of the emissions of telecommunication...
What are the main applications for continuous measurement equipment?

What are the main applications for continuous measurement equipment?

There are two main applications: monitoring of a given telecommunication facility and monitoring of places of special importance (schools, nursery schools, hospitals, etc.).
Where is the best place to install continuous measurement equipment?

Where is the best place to install continuous measurement equipment?

There are different basic criteria, namely technical and social. According to technical criteria, the equipment should be installed where we can measure the highest possible level. This allows us to...
What is the main function of portable measurement systems (SMP)?

What is the main function of portable measurement systems (SMP)?

Portable measurement systems allow us to verify whether a place is suitable for public access and certify that telecommunication facilities comply with current applicable regulations on electromagnetic...
What do I need to do to certify telecommunication base stations?

What do I need to do to certify telecommunication base stations?

All you need is a portable measurement device with a probe that is suitable to the service that you wish to measure and a tripod to set up the device and leave it working while the measurement is taken...
Why is the “sliding window” function important?

Why is the “sliding window” function important?

Most national and international standards require averaging of measurements over a 6-minute time frame. The regulatory limit must be complied with in any of those averages, i.e. over any 6-minute period....
What makes the WPT probe special and unique?

What makes the WPT probe special and unique?

The WPT probe has been designed specifically for measuring mobile telephone frequencies. What makes it special is precisely the fact that it only measures mobile telephone frequencies and ignores any...
What do I need to do when I want to change the probe?

What do I need to do when I want to change the probe?

Nothing at all, since Wavecontrol devices are equipped with an automatic probe detection system, so that when you connect a different probe, the device recognises it and is then ready to measure again....
What is the purpose of a GPS in the SMP?

What is the purpose of a GPS in the SMP?

The GPS indicates the position of the data that is being gathered. When you take a measurement using the SMP with the GPS switched on, the data is stored in the memory along with the GPS position. This...
What are the advantages and drawbacks of using broadband probes?

What are the advantages and drawbacks of using broadband probes?

Broadband probes cannot discriminate frequencies, i.e. they cannot measure the contribution of different services to the total level of exposure. Their advantage is that they allow us quickly and easily...
1 | 2
Pallars 65-71 | 08018 Barcelona (Spain) | Phone: +34 933 208 055 | Fax: +34 933 208 056
Terms of use | Contact us | Terminology